Screw M10x45, AISI304

Screw DIN 912 – M10x45 mm, AISI 304 (A2), Allen bolt, type of steel – A2

The Strofix screw M10×45 is an AISI 304 (A2) stainless-steel hex socket head cap screw manufactured to DIN 912 standard. The screw has an M10 thread and 45 mm length. It is tightened using a hex (Allen) key.

The DIN 912 hex socket cap screw is a standard fastener used in railing, balustrade, and architectural glass fixing assemblies. In a counterbored hole the cylindrical head can sit flush with the surface. The M10 thread matches the bolt holes of many Strofix railing post base plates and structural fixings. AISI 304 (A2 grade) stainless steel provides corrosion resistance for both interior and exterior installations.

This SKU is a single fixed configuration – M10×45 mm, AISI 304 only.

Use cases:

• Securing railing post base plates to anchor rods or threaded inserts
• Glass clamp and glass adaptor bolt assemblies
• Spigot base glass clamp fixing
• General stainless-steel fastening in railing and balustrade systems
• Any M10 bolt application requiring a hex socket head in AISI 304

FAQ:

What are the screw dimensions?

The screw has an M10 thread and 45 mm length (M10×45 mm).

What standard does this screw conform to?

The screw is manufactured to DIN 912, which specifies hex socket head cap screws (also known as Allen bolts or socket head cap screws). This is equivalent to ISO 4762.

What tool is required?

A hex (Allen) key is required to tighten and loosen this screw. The hex socket is recessed into the bolt head.

What steel grade is used?

The screw is AISI 304, designated A2 under the European stainless-steel fastener classification. A2 stainless steel provides corrosion resistance for standard interior and exterior applications.

Where is this screw used in railing installations?

The M10×45 screw is used in base plate assemblies, glass clamp fixings, and other bolted connections in Strofix railing and balustrade systems. The specific screw quantity and placement depend on the component being installed.

About Anchors & Screws

Anchors and screws fix glass adaptors, French balcony holders, brackets, railing posts and other hardware to the building – to concrete, masonry, insulated façades or timber.

The range covers S235 steel anchor rods (Ø16 mm with an internal M8 and Ø20 mm with an internal M10 thread, 220–400 mm) for chemical anchoring, a zinc-plated anchor sleeve M10 × 80 mm, a PVC spacer sleeve for fixings through insulation, AISI 304 threaded rods and studs (M10 × 200 threaded rod, M10 × 50 set screw, M8 × 60 and M10 × 100 double threads for timber), DIN 912 screws, DIN 917 cup nuts, flat washers, and wood screws Ø8 and Ø10 mm in AISI 316 or coated carbon steel in RAL colours.

The right fastener depends on the substrate, the façade build-up, the thread size of the fitting and the load.