Corner handrail plate - Flat, 90º

The Strofix corner handrail plate (90°) flat is a stainless-steel saddle plate that seats a handrail at a 90° corner on a flat surface. The plate measures 43 × 24 mm with a flat profile, suited to flat-topped or capped rails. Manufactured from AISI 304 stainless steel with a satin finish. This is a fixed (non-adjustable) plate.

This corner plate is used where a handrail turns a right-angle (90°) corner — it seats the rail at the corner point and is screwed to the supporting post fitting or element. Unlike the straight handrail plate (64 × 24 mm), the corner plate is shorter (43 × 24 mm) and configured for the rail's change of direction at the corner. The flat profile suits flat-topped or capped rails; a 42.4 version is available for round ø42.4 mm tube. As a fixed plate, it holds the defined 90° geometry.

Use cases:

• Seating a flat-topped handrail at a 90° corner on a railing post
• Right-angle corner support point in a continuous handrail run
• Corner termination plate for flat-profile rails on post railing systems
• Stainless-steel 90° corner handrail plate for flat surfaces
• Handrail direction changes at balcony or landing corners

FAQ

What is a corner handrail plate?

It is a saddle plate configured to seat a handrail where it turns a 90° corner, transferring the rail load to the support below at the corner point. It differs from the straight handrail plate, which seats a rail along a straight run.

What handrail profile does it fit?

Flat-topped or capped rails, via its flat 43 × 24 mm profile. For a round ø42.4 mm tube, use the corner 42.4 version.

Is it adjustable?

No. This is a fixed plate holding the 90° corner geometry.

What steel grade is used?

AISI 304 stainless steel with a satin finish.

What are the plate dimensions?

43 × 24 mm — shorter than the 64 × 24 mm straight handrail plate.