End cap for pipe ø12mm 20mm, Polished

The Strofix rod end cap is an AISI 304 stainless-steel closure for Ø12 mm solid crossbar rod, 20 mm high, with a polished finish.

It fits over the cut end of the horizontal infill rod and is supplied with the screwing elements needed to fix it. Closing the rod end keeps water and debris out of the section and gives the balustrade a finished termination instead of a bare cut face.

AISI 304 stainless steel is suitable for standard interior and exterior installations. This SKU is a single fixed configuration – Ø12 mm rod, 20 mm height, polished only.

Use cases:

• Closing the cut end of a Ø12 mm horizontal infill rod
• Finishing rod-infill balustrades on balconies and terraces
• Sealing the rod end against moisture inside the hollow section
• Giving a clean termination where the rod meets the post
• Workshop prefabrication of rod-infill railing panels

FAQ:

What rod does this end cap fit?

It fits Ø12 mm solid crossbar rod. The cap is 20 mm high.

How is it fixed to the rod?

Screwing elements are included. The cap fits over the rod end and is secured with the supplied screw – no welding or adhesive is needed.

What steel grade is used?

AISI 304 stainless steel with a polished finish.

Are other heights available?

Yes. Strofix supplies rod end caps in 15, 20, 25 and 30 mm heights for Ø10 and Ø12 mm rod, in satin and polished finishes.

Can I fit it myself?

Yes. It needs only a screwdriver or hex key. The rod end should be cut square and deburred first.

About End Caps

An end cap is a stainless-steel closure piece that plugs into or fits over the open end of a railing tube, post or solid bar, sealing it against moisture ingress and giving the termination a clean, finished appearance. Without an end cap, the cut tube end is exposed – visually unfinished and prone to collecting water and debris inside the hollow section.

Strofix supplies 13 end cap products in three profile families: caps for Ø42.4 mm round pipe (available in flat, convex and ellipsoid shapes), caps for 40×40 mm flat square tube (flat profile), and caps for Ø10 and Ø12 mm solid crossbar rods.

All are in AISI 304 stainless steel with a satin finish, with AISI 316 and polished options available on selected variants. The correct end cap depends on the tube or rod profile it will close, and the desired cap shape.